ii
Setting the media .........................................................................2-4
Set the media in another method ...................................................... 2-6
Test printing .................................................................................2-7
Perform test printing with the test pattern for checking white ink ...... 2-8
Head Cleaning .............................................................................2-8
About head cleaning.......................................................................... 2-8
Perform head cleaning depending on the test printing result ............ 2-8
Printing an image from source data .............................................2-9
Starting the printing operation ........................................................... 2-9
Interruption of printing ....................................................................... 2-9
Checking printing data that is being received or has been
received........................................................................................... 2-10
When [! WORK High] is displayed................................................... 2-10
If you open the cover during printing ............................................... 2-10
Chapter 3 Setup
About Head Height MENU ...........................................................3-2
Head Height MENU table .................................................................. 3-2
Setting the Media Thickness ............................................................. 3-3
Setting the HEAD GAP...................................................................... 3-3
Gap check ......................................................................................... 3-3
Table spacer...................................................................................... 3-3
About ORIGIN SETUP MENU .....................................................3-4
ORIGIN SETUP MENU table ............................................................ 3-4
Setting the X offset (REM)................................................................. 3-5
Setting the Y offset (REM)................................................................. 3-5
Setting the X offset (LOC) ................................................................. 3-5
Setting the Y offset (LOC) ................................................................. 3-5
Setting the Z origin ............................................................................ 3-6
Changing the origin using the JOG keys........................................... 3-6
About SETUP MENU ...................................................................3-8
SETUP MENU table .......................................................................... 3-9
Setting of Media Correction............................................................. 3-10
Setting of LOGICAL SEEK .............................................................. 3-10
Setting of INK LAYERS ................................................................... 3-11
Setting of REFRESH LEVEL........................................................... 3-11
Setting of UV MODE ....................................................................... 3-11
Setting of WORK CHANGE............................................................. 3-11
Setting of FAN MODE ..................................................................... 3-12
Setting of AUTO CLEANING........................................................... 3-12
Setting of PRINT FLUSHING LEVEL .............................................. 3-12
Setting of MAPS4 ............................................................................ 3-13
Setting of the Misregistration adjust ................................................ 3-14
About MACHINE SETUP MENU ................................................3-16
MACHINE SETUP MENU table ...................................................... 3-17
Setting a AUTO Power-off............................................................... 3-18
Setting Time .................................................................................... 3-18
Setting Unit (Temperature/ Length)................................................. 3-18
Setting a KEY BUZZER................................................................... 3-19
Set the network ............................................................................... 3-19
Setting event mail function .............................................................. 3-20
To Next Page
Loading...
