Mindray BP10 NIBP Module - 4 Configuring BP10; Introduction; Configuring the Display; Configuring the Display Brightness

Introduction Configuring BP10
4 - 2 BP10 Operator’s Manual
4.1 Introduction
This chapter describes the configurations that you may need to do.
4.2 Configuring the Display
4.2.1 Configuring the Display Brightness
To configure the display brightness, follow this procedure:
1. Enter the main menu.
2. Select System.
3. Select Display Brightness. The Display Brightness menu displays.
4. Select Screen Brightness and adjust the brightness ranged from 1 to 10. The
bigger value indicates a brighter level.
5. Press the key to save the setting.
6. Press the key to exit the menu.
4.2.2 Configuring the Display Auto Off
You can configure the display to automatically turn off when the configured time is
reached.
1. Enter the main menu.
2. Select System.
3. Select Maintenance. The correct passcode is required to enter the Maintenance
menu.
4. Select Display Auto Off.
5. Select the appropriate time.
6. Press the key to save the setting.
7. Press the key to exit the menu.
4.3 Switching On/Off the Audio
You can independently switch on/off the technical message audio and keypad audio.
The method for switching on/off the two kinds of audio is same.
To switch on/off the audio, follow this procedure:
1. Enter the main menu.
2. Select System.
3. Select Audio Volume.