Configuring the NIBP Setup Monitoring NIBP
6 - 6 BP10 Operator’s Manual
6.5.1 General NIBP Setup
6.5.2 Advanced NIBP Setup (Passcode Protected)
The following table lists the configurable options.
Options Description How to Enter Settings*
Mode Selects the NIBP measurement
mode.
Refer to
"Configuring NIBP
Measurement Modes
" on
page 6-7 for additional
information.
Enter the main menu and
select
Mode.
Manual, Interval,
Sequence, ABPM
NIBP Color Selects the NIBP parameter
color.
1. Enter the main menu.
2. Select
System.
3. Select
NIBP Color.
6 colors
The default color is white.
Initial Pressure Selects the initial cuff inflation
pressure.
1. Enter the main menu.
2. Select
Patient Info.
3. Select
Initial Pressure.
Adult: 80 -280 mmHg.
Default: 160mmHg.
Pediatric: 80 - 210 mmHg
Default:140 mmHg
* The factory default settings are in bold.
Options Description How to Enter Settings*
NIBP Timeout Configures the retention time of the
measurement value each time it is
obtained.
If OFF is selected, the measurement
value retains till the next measurement
starts.
1. Enter the main menu.
2. Select System →
Maintenance. A passcode
screen displays.
3. Enter the correct
passcodes.
4. Select NIBP Settings.
5 min, 10 min,
15 min, 30 min,
45 min, 60 min,
OFF
NIBP Endtone Configures it to issue a reminder tone at
the completion of a NIBP measurement.
ON, OFF
Measure on
Clock
Configures it to automatically take an
NIBP measurement on the fixed time
based on the interval.
For example, in a situation that Measure
on Clock is set to ON, and Interval is 20
min, if the first measurement is taken at
14:03, the following measurements will
be taken at 14:20, 14:40, 15:00 and so on.
ON, OFF
Units Configures the NIBP measurement unit. mmHg, kPa
* The factory default settings are in bold.
To Next Page
Loading...
