Technical Alarms with TD60/TM80 Troubleshooting
12 - 4 BP10 Operator’s Manual
12.3 Technical Alarms with TD60/TM80
When BP10 is connected to TD60/TM80, the technical messages will internally convert
into alarms and send to TD60/TM80.
Refer to TMS60 Telemetry Monitoring System/TM80 Telemetry Monitor Operator's
Manual (P/N: 046-011232-00) for technical alarm details.
12.4 Physiological Alarms with Central Monitoring
System
BP10 does not provide any physiological alarms or messages.
When BP10 is connected to TD60/TM80, the NIBP parameter measurements at BP10 will
send to TD60/TM80, and then TD60/TM80 transmits them to the CMS. The CMS is the
sole system to provide the physiological alarms and message for BP10 NIBP
measurements.
NIBP-S Overrange No The measured NIBP value is not
within the measurement range.
Contact your service personnel.
NIBP-D Overrange No
NIBP-M Overrange No
Message
Clearable
(Yes/No)?
Possible cause Solution
To Next Page
Loading...
