Mindray BP10 NIBP Module - Charging the Rechargeable Lithium-Ion Battery

Charging the Rechargeable Lithium-ion Battery Battery
8 - 4 BP10 Operator’s Manual
• Remove the battery before transporting the device or if the device is not in
use or is being stored.
NOTE
• Retain the NIBP hose with the device while removing the battery.
1. Lift up the lithium-ion battery pack or AA alkaline battery tray at the bottom of
BP10.
2. Remove the lithium-ion battery pack or AA alkaline battery tray from BP10.
8.6 Charging the Rechargeable Lithium-ion Battery
WARNING
• Only use the specified central charger to charge to the lithium-ion batteries
designated by Mindray.
• Only use the approved power cord with the grounded mains plug to firmly
connect the central charger to a grounded AC mains socket. Never refit the
mains plug to fit an ungrounded AC mains socket.
• Do not use the Multiple Portable Socket Outlets (MPSO) or AC mains
extension cords. Use an IEC 60601-1 approved isolation / separation
transformer, otherwise, it may result in leakage current. Insure that the sum
of the individual ground leakage currents does not exceed the allowable
limits.
• Do not place any shield object (such as cloth or paper) to cover the central
charger or batteries, and keep ventilated while charging the lithium-ion
batteries.
• Do not connect other devices to the power supply system.
• Do not use the central charger to charge the lithium-ion batteries in high
temperature above 40°C.