Battery Installing the Battery
BP10 Operator’s Manual 8 - 3
place aside until it cools. Then remove the battery from the device, and
contact your service personnel to identify the cause of overheating.
• Replace the battery immediately once the “Battery Depleted” message
displays. Replace the battery in time once the “Low Battery” message
displays. If those conditions are not corrected, device shutdown and
cessation of monitoring will result. After replacing the rechargeable lithium-
ion battery, charge it in time. Do not store the lithium-ion battery whose
batter power is depleted but is not charged yet.
• To eliminate the risk of electrical shock or burn, do not carry loose batteries
on your person, such as placing the battery in clothing pockets.
• Remove the battery before transporting the device or if the device is not in
use or is being stored.
• AA alkaline batteries should be removed from the device at the end of the
battery’s useful life to prevent leakage. In case of battery leakage, use
caution to remove the batteries and clean the battery compartment. Install
fresh AA batteries and check if BP10 can power on properly. If the BP10 fails
to power on, contact your service personnel.
8.3 Installing the Battery
Refer to "Installing the Batteries" on page 3-4 for details.
8.4 Checking the Battery Charge Status
The battery symbol displaying on the top of main screen indicates the battery charge
status. The white part ( ) indicates the remaining battery charge.
8.5 Removing the Battery
• Some failure conditions, such as short circuits, can cause a battery to
overheat during using. High temperature can cause burns to the patient or
user. If the device becomes too hot to touch, remove it from the patient and
place aside until it cools. Then remove the battery from the device, and
contact your service personnel to identify the cause of overheating.
• Avoid scraping the metal contact in the battery compartment while
removing the lithium-ion battery pack or AA battery frame. Otherwise, the
broken contact will affect the power supply performance.
To Next Page
Loading...
