Powering On the Device Getting Started
3 - 6 BP10 Operator’s Manual
3.5 Powering On the Device
When the rechargeable lithium-ion or AA battery is properly installed into the
compartment door, BP10 will be powered on automatically.
When BP10 is powered off, press the key to turn on BP10. The startup logo screen
displays and a beep sounds.
Upon powering up, there are two situations:
■ If BP10 is turned on for the first time, the device will request you to set up
language, maintenance passcode, service passcode for the first time startup.
■ If BP10 is turned on next time, the device will directly go to the main screen.
• Do not use the equipment for any NIBP measurement on a patient if you
suspect the equipment is not working properly or if the equipment is
mechanically damaged. Contact your service personnel or Mindray.
3.6 Basic Operations
This section describes the basic operations for BP10.
• Patients should be instructed not to open the battery compartment while
BP10 is in use.
3.6.1 Entering the Main Menu
Press the key to enter the main menu.
The main menu allows access to most of the system functions and settings.
To Next Page
Loading...
