Pairing with a TD60/TM80 Connection with External Systems
7 - 2 BP10 Operator’s Manual
7.1 Pairing with a TD60/TM80
You can pair BP10 with a TD60/TM80. After pairing, TD60/TM80 can display the NIBP-
related data and messages. You can only pair BP10 with the TD60/TM80 by operating a
TD60/TM80. Refer to TMS60 Telemetry Monitoring System/TM80 Telemetry Monitor
Operator's Manual (P/N: 046-011232-00) for the pairing procedure.
• Unpair BP10 with TD60/TM80 each time you stop monitoring the patient by
pressing the key at BP10.
• Always discharge the patient before BP10 is used on the new patient.
• Always make sure that BP10 is applied on the correct patient.
If BP10 is paired with a TD60/TM80, the following operation is disabled at BP10:
■ Entering Standby mode
■ Discharging a patient
■ Setting NIBP measurement mode
■ Changing patient category
• In ABPM mode, all the historic data at BP10 will be cleared if you select to
continue the patient from TD60/TM80.
7.2 Connecting with Central Monitoring System
BP10 can be connected to the central monitoring system via TD60/TM80.
Refer to BeneVision Central Monitoring System Operator’s Manual (P/N: 046-010879-
00) for additional information.
To Next Page
Loading...
