EMC
B - 6 BP10 Operator’s Manual
• The device is configured with a wireless network connector to receive
wireless signal. Other devices may interfere with this device even though
they meet the requirements of CISPR.
Recommended separation distances between portable and mobile RF communication and
the system
The device is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The customer or the user of the device can help prevent
electromagnetic interference by maintaining a minimum distance between portable and mobile
RF communications equipment (transmitters) and the device as recommended below, according
to the maximum output power of the communications equipment.
Rated Maximum
Output power of
Transmitter W
(Watts)
Separation Distance According to Frequency of Transmitter M
(Meters)
150kHz -80MHz
d = 1.2
80MHz to 800MHz
d = 1.2
800MHz to 2.5GHz
d = 2.3
0.01 0.12 0.12 0.23
0.1 0.38 0.38 0.73
1 1.20 1.20 2.30
10 3.80 3.80 7.30
100 12.00 12.00 23.00
For transmitters rated at a maximum output power not listed above, the recommended separation
distance d in metres (m) can be estimated using the equation applicable to the frequency of the
transmitter, where P is the maximum output power rating of the transmitter in watts (W) according
to the transmitter manufacturer.
Note: At 80 MHz to 800 MHz, the separation distance for the higher frequency range applies.
Note: These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
To Next Page
Loading...
