Mindray DC-30 Service Manual

8-6 Options Installation
8.3.5 Assembling/Disassembling
Tools required: type-2 screwdriver
Unscrew the four M2.5 flat-headed screws and remove the rear cover of the printer adapter, as
shown in the following figure:
The disassembled printer adapter is shown as follows:

Mindray DC-30 Specifications

General

DICOM	Yes
Hard Drive	500 GB
Continuous Wave Doppler	Yes
Tissue Harmonic Imaging	Yes
Relative Humidity	30% to 85% (non-condensing)
Imaging Modes	Color Doppler, Power Doppler
Power Supply	100-240 V~ 50/60 Hz
Probe Connectors	2 active probe connectors
Probe Types	Convex, Linear, Phased Array
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to +55°C
Transducer Ports	2