Mindray DC-30 Service Manual

Software installation and Maintenance 6-1
6 Software installation and
Maintenance
WARNING: DO NOT directly remove a USB memory device; otherwise,
the USB memory device and / or the system may be damaged.
6.1 Enter the Maintenance Window
NOTE:
Log on the system with the identity of Service before perform system
maintenance.
To log on the system:
1. When access control function has not been activated: press “Ctrl+/” to show the
Login dialogue box, and then select the Service as the user name.
2. When access control function has been activated already: press “Ctrl+/” when the
Login dialogue box is displayed, and then select the Service as the user name.
3. Press <Setup> key to open the Setup menu, click [Maintenance] to enter [Other]
menu and then select the target items to perform the maintenance respectively.

Mindray DC-30 Specifications

General

DICOM	Yes
Hard Drive	500 GB
Continuous Wave Doppler	Yes
Tissue Harmonic Imaging	Yes
Relative Humidity	30% to 85% (non-condensing)
Imaging Modes	Color Doppler, Power Doppler
Power Supply	100-240 V~ 50/60 Hz
Probe Connectors	2 active probe connectors
Probe Types	Convex, Linear, Phased Array
Operating Temperature	10°C to 40°C
Storage Temperature	-20°C to +55°C
Transducer Ports	2