Name: Mindray DC-30
Brand: Mindray
Rating: 4 (1 reviews)

To Next Page

To Previous Page

3-10 System Installation

3.4 Installing Peripherals

For the models of the supported peripherals, please refer to “2.1.3 Supported Peripherals”.

3.4.1 Footswitch Installation

1. Connecting: insert the USB connector to the system applicable USB ports (in the rear

of the machine or left of control panel).

2. For settings of footswitch, please refer to 3.5.3 System Preset.

3.4.2 Installing a Graph / Text Printer

3.4.2.1 Connecting a Local Printer

As shown in the figure below, a graph / text printer has a power cord and data cable. The

power cord shall be directly connected to a wall receptacle as required.

1. Connect the data cable with the USB port on the ultrasound system.

2. Connect the power cord to an appropriate power supply that is well grounded.

3. Power on the system and the printer.

4. Check the printer status:

 Enter [Setup]-> [Print Preset]->“Printer Driver” page, printers that are installed

automatically will be displayed in the list with the “Status” of “Ready”.

Data cord

USB port

Power cord

Questions and Answers:

Need help?

Do you have a question about the Mindray DC-30 and is the answer not in the manual?

Mindray DC-30 Specifications

General