13 - 54 Operator’s Manual
13 Probes and Biopsy
c. Hold the probe. Press the biopsy needle pressure position to separate it from the needle
guided V-shaped guiding block. Put the needle into the V-shaped guiding block of the
needle guided-bracket.
d. Hold the probe, and release the pressure position of the needle. Adjust the needle-shaped
adjusting nut manually (following the direction of the arrow). The needle moves smoothly
at the vertical direction due to its gravity.
2. Remove the needle-guided bracket:
a. Hold the probe. Press the biopsy needle pressure position to separate the biopsy needle
from the pressure position. Separate the bracket and the probe from the needle.
To Next Page
Loading...
