B Wireless Charging
Operator’s Manual B - 5
2. Clean the floor and ensure it is clean, flat and smooth.
3. Observe the wall. If the pad is required, please see “B.1.2 Installing the Pad”.
4. Select an appropriate cushion pad according to the gap between the Air Station and the wall (or
the pad), and attach it to the back of the Air Station, as shown in the following figure.
5. Install the Air Station against the wall (or the pad) to the ground.
If there is a guide plate, place the suction cup side of the guide plate upward, organize and put
the power cord into the groove, and reserve about 15~25cm length of the power cord, as shown
in the following figure.
To Next Page
Loading...
