B - 6 Operator’s Manual
B Wireless Charging
6. Connect the power cord to the external power supply and use a Velcro to organize the power
cord.
Wall Mounting Method
If wall mounting installation is selected and the pad is installed, the operation steps are as follows:
1. Mark a straight line at the pad 15 cm above the ground with a marking pen.
2. Keep the bottom of the wall mounting bracket against the straight line, and fix the wall
mounting bracket to the wall using a hammer and steel screws.
3. Select an appropriate cushion pad according to the gap between the transmitting module and
the pad, and attach it to the back of the transmitting module, as shown in the following figure.
To Next Page
Loading...
