B - 8 Operator’s Manual
B Wireless Charging
2. Use a marking pen to mark the position of the mounting hole on the wall mounting bracket.
3. Use a percussion drill to drill holes in the four marked positions on the wall, with a diameter of
6 mm and a depth of 30 mm.
4. Hit the expansion rubber stopper into the drilled hole with a hammer.
5. Use four tapping screws to fix the wall mounting bracket to the expansion rubber stoppers.
6. Select an appropriate cushion pad according to the gap between the transmitting module and
the wall, and attach it to the back of the transmitting module, as shown in the following figure.
7. Connect the power cord with the external power supply and use a Velcro to organize the power
cord.
To Next Page
Loading...
