Revision:1.0(2023–5–17)
61
7 Troubleshooting
7.1 System Diagnosis and Support
7.1.1 Self-test
The wireless probe is diagnosed based on its self-test function and monitoring logs.
Self-test: The product runs self-test items to determine whether it is functioning properly.
Monitoring logs: The logs record key information and accidental problems during use of the
product.
The self-test function is under development, and the relevant content will be added later.
7.1.2 Monitoring
This function is under development. Content to be added.
7.2 Troubleshooting for Errors Without Alarm
Reporting
7.2.1 Boot Failures
77..22..11..11 Boot Failure
Fault Description
The probe cannot be turned on.
Involved FRU
Wireless probe
Severity
Suspension
Response
Contact the device provider for onsite troubleshooting.
Possible Causes
Diagnostic Ultrasound System
Service Manual
7 Troubleshooting
To Next Page
Loading...
Need help?
General
