Revision:1.0(2023–5–17)
43
3.3.4 Charging
33..33..44..11 Using an Power Outlet to Charge the Wireless Probe
We recommend that you turn off the wireless probe before charging it. In this case, the probe can
be fully charged in no more than 45 minutes.
1.
Connect the wireless probe to a power outlet using the charging cable, as shown in the
following figure (no figure for the software).
2. In charging state, the three-segment battery indicator and the lightning flash status indicator on
the wireless probe act as follows:
1)When the battery level is lower than 20%, the battery indicator is off, and the status indicator
stays orange.
2)When the battery level is equal to or higher than 20% and lower than 40%, segment 1 of the
battery indicator blinks, and the status indicator stays white.
3)When the battery level is equal to or higher than 40% and lower than 70%, segment 1 of the
battery indicator stays on, segment 2 blinks, and the status indicator stays white.
4)When the battery level is equal to or higher than 70% and lower than 95%, segments 1 and 2
of the battery indicator stay on, segment 3 blinks, and the status indicator stays white.
5)When the battery level is equal to or higher than 95%, all segments of the battery indicator stay
on, and the status indicator stays white.
When the both battery indicator and status indicator stay white, the wireless probe has been fully
charged.
33..33..44..22 Using the Charging Station to Charge the Wireless Probe
We recommend that you turn off the wireless probe before charging it. In this case, the probe can
be fully charged in no more than 45 minutes.
1.
Insert the wireless probe into the charging station on the TEX machine, as shown in the
following figure (no figure for the software).
2. In charging state, indicators on the charging station act as follows:
1)When the wireless probe is being charged, the corresponding indicator stays orange.
2)When the wireless probe is fully charged, the corresponding indicator stays green.
33..33..44..33 Using the Charging Case (Air Capsule) to Charge the Wireless
Probe
We recommend that you turn off the wireless probe before charging it. In this case, the probe can
be fully charged in no more than 45 minutes.
1.
Insert the wireless probe into the Charging Case (Air Capsule), as shown in the following figure
(no figure for the software).
Diagnostic Ultrasound System
Service Manual
3 How to Use