Mindray Z60T - Page 162

11-8 DICOM
Name
Description
Display Format
Specify quantity of printed files,e.g. STANDARD\2, 3
indicates 6 images are printed for each page.
Medium Type
Specify print medium: Paper, Clear Film, Blue Film.
Trim
Specify whether you want a trim box to be printed around
each image on the film: Yes or No.
Min Density Enter the minimum density of the film
Max Density
Enter the maximum density of the film.
Configuration Info Enter configuration information in the field.
Destination
Specify where the file is exposed:
MAGAZINE (stored in the magazine), or
PROCESSOR (exposed in the processor)
Magnification Type
Replicate: interpolated pixels belong to duplicate of adjacent
pixels;
Bilinear: interpolated pixels are generated from bilinear
interpolations between adjacent pixels;
Cubic: interpolated pixels are generated from cubic
interpolations between adjacent pixels; None: without
interpolation.
Select how the printer magnifies an image to fit the film.
[Add] Add the DICOM service to the service list.
[Cancel] Click to cancel the parameter setting.
[Update]
Select an item in the service list, change the parameters in
the above area, and click [Update] to update the item in the
service list.
[Delete]
Click to delete the selected service in the service list.
[Default]
Select an item in the service list, click [Default] and you can
see “Y” in the Default column.
[Verify]
Click to verify if the two DICOM application entities are
normally connected.
[Exit]
Click to exit the screen.
Parameter setting should be consistent with the printer performance:
 For instance, if the printer cannot support film size to be “8IN*10IN”, please select the
printer supported size.
 Settings: RGB is color printing and MONOCHROME2 is black and white printing.
 Medium Type: for black and white printing, usually Blue Film or Clear Film is used,
and for color printing, Paper is usually used. For details, please refer to printer
conformance statement.
 Change the setting if necessary.
11.1.3.3 DICOM Worklist
1. On DICOM Service screen, click [Worklist] page tab to enter the Worklist page.
2. Select device, enter the right AE Title, port, etc.
3. Click [Add] to add the service to the Service List.