Image Optimization 5-19
Gray Map
This function applies the gray correction to obtain the optimum images.
Click the [Gray Map] item on the image menu.
Duplex/ Triplex
This function is used to set if B image (B + Color image) and PW image are
displayed synchronously.
Click [Duplex/ Triplex] on the image menu to turn on or off the synchronization.
Auto Calculation
This function is used to trace the spectrum and calculate parameters of
PW/CW mode image, and the results of which are displayed in the result
window.
Calculation
Turn on or off the auto calculation function through the [Auto Calc] item on the
image menu.
Auto
Calculation
Parameter
Select parameters in the dialogue box prompted by clicking [Auto Calc Param]
on the image menu.
Auto Calc
Cycle
To set the number of heart cycle for auto calculation.
Click [Auto Calc Cycle] on the image menu to select the cycle number.
In real-time scanning, the results displayed are derived from the calculation of
latest cardiac cycle;
In the freeze and cine status, the results displayed are calculated from the
current selected area.
Trace
Trace Area
To set the trace area of the Doppler wave in the spectrum map, applicable for
auto calculation.
Change the trace area through the [Trace Area] item on the image menu.
The available selections are: Above, Below, All.
To Next Page
Loading...
Need help?
General
