3.7 Photo Burst Capture Mode & Settings Menu
Photo Burst automatically captures photos sequentially based on the setting defined in
the menus. Press the shutter button and the camera will begin capturing automatically.
Note that when shooting in this mode, the Flash is disabled and cannot be used.
1.
Line up your shot by looking at the LCD screen to see what is in the shot.
2.
Press the SHUTTER button halfway to focus on the subject. When the focus frame
turns green, press the SHUTTER button down completely to capture the photo.
3.
When half-pressing the SHUTTER button, the lens will attempt to focus on your
intended subject. Once a satisfactory focus is achieved, the monitor will display a
green rectangle to notify you that it has a achieved a clear focus. You may then fully
press the SHUTTER button to the capture the photo. If the monitor displays a red
rectangle, then the lens cannot achieve a clear focus and you need to adjust your
shooting distance or the photo will capture blurry.
4.
The number of photos that can be captured at a particular resolution will be displayed
in the top right corner of the screen.
5.
The number of remaining photos is determined by the selected photo resolution. The
higher the photo resolution, the lower the number of photos you are able to be save to
the memory card. Before capturing any photos, you can select a preferred photo
resolution.
To Next Page
Loading...
