Minolta MND55 - Date & Time Setup; Format Memory Card; Camera System Information; Restore Default Settings

button to confirm your selected option (YYYY/MM/DD, MM/DD/YYYY, DD-MM-
YYYY).
6.
Press the MENU button to exit the settings menu without making a selection.
3.7.17 Date & Time Setup
This function allows you to set the current Date and Time on your recorded video clips
and captured photos.
1.
In Photo Burst Mode press the MENU button.
2.
Select the Gear icon on the bottom of the left side of the screen by pressing the LEFT
button, and then pressing the DOWN button.
3.
Press the RIGHT button to enter the setup menu.
4.
Select up using the UP or DOWN buttons and press the MODE/OK
button to enter the up menu.
5.
Press the UP or DOWN buttons to change the value of the highlighted field.
6.
Press the LEFT or RIGHT buttons to change to the next field.
7.
Press the MODE/OK button to save the date and time and to exit the settings menu.
8.
You can also press the MENU button to exit the settings menu without making a
selection.
3.7.18 Format Memory Card
The format setting erases all photos, videos and data stored on your memory card.
1.
In Photo Burst Mode press the MENU button.
2.
Select the Gear icon on the bottom of the left side of the screen by pressing the LEFT
button, and then pressing the DOWN button.
3.
Press the RIGHT button to enter the setup menu.
4.
Select using the UP or DOWN buttons and press the
MODE/OK button to enter the menu.
5.
Press the LEFT or RIGHT buttons to navigate the menu, and press the MODE/OK
button to confirm your selected option (Format, Cancel).
6.
Press the MENU button to exit the settings menu without making a selection.
NOTE: This will delete all of your media and cannot be undone.
3.7.19 Camera System Information
This setting displays the current firmware version of your camera.
1.
In Photo Burst Mode press the MENU button.
2.
Select the Gear icon on the bottom of the left side of the screen by pressing the LEFT
button, and then pressing the DOWN button.
3.
Press the RIGHT button to enter the setup menu.
4.
Select using the UP or DOWN buttons and press the
MODE/OK button to enter the menu.
5.
Press the OK button to exit, and press the MENU button to exit the settings menu
without making a selection.
3.7.20 Restore Default Settings
Factory default settings can be restored in this menu. This function will not delete the
factory default settings.
1.
In Photo Burst Mode press the MENU button.
2.
Select the Gear icon on the bottom of the left side of the screen by pressing the LEFT