49
The following message is displayed to bypass.
If the device is already bypassed the message is as follows.
If the exclamation is not used, then there will be individual confirmation.
At the end of the bypass operation or if the exclamation is used, the message displays:
5. List Unbypass
A list of devices can be bypassed using this option. The user is prompted to enter the loop
number to be unbypassed.
Enter the list to unbypass, the last list bypassed will be displayed.
If the list to be unbypassed is shown, just press Enter to complete the unbypassing.
Otherwise, you may unbypass the devices one, two or more at a time.
If you are attempting to unbypass items that are already unbypassed you will get an “Already
un-bypassed” message.
Otherwise, if the exclamation is not used, then there will be individual confirmation.
At the end of the un-bypass operation or if the exclamation is used, the message displays:
Loop number
Loop :__
To Next Page
Loading...
Need help?
General
