To Next Page

To Previous Page

QX-5000 Series Installation and Operation Manual

ULI Specifications

Overall

• 0 to 49 degrees Celsius, 0 to 95% RH (non-condensing) operating range

• Power input: 120 VAC, 60Hz, 12A (primary)

• Power supply ratings: 30A, 40V (secondary)

Model QIF-5000B Interface Module

• 2 Class B indicating circuits, one silenceable, one non-silenceable circuit connect to a fire alarm control panel

• 1 trouble contact output to a fire alarm control panel

• 1 GA contact input from a fire alarm control panel to allow two-stage operation

• 1 Bell cut drive for an external bell cut relay to a fire alarm control panel

• Fully supervised interface to QMP-5100B Master Paging Module

• Microcontroller based with full Watchdog Timer operation

• One minute paging inhibit after the first alarm

• Supervised pre-amplifier & tone generators

•Lamp test

• 18-1/2" high, 5-1/4" deep

• Current Consumption: standby: 200mA

alarm: 200mA

Model QPS-5000 & QBC-5000B Power Supply & Charger

• Primary input 120 VAC +10%, -15%, 60Hz, 12Amp

• Charging for up to 65 AH of 24 VDC batteries

• Float Type Charger

Model QMB-5000B Motherboard and Card Cage

• Accommodates one QIF-5000B, and up to seven amplifiers (360 Watts MAX speaker load). Connections for

QPS-5000, QBC-5000B, Batteries, and expansion connection to another QMB-5000B.

Model QAA-5160-70/25 Amplifier with one 70V or 25V, 60 Watt Zone

• 70.7Vrms or 25V constant voltage output

• One fully supervised Class "A" or "B" speaker Zone

• 60 watts per zone

• Freq. Response: ULI bandwidth from 800 to 2800 Hz

• Harmonic distortion less than 2.5% at 1 KHz

• Current consumption: standby: 55mA

alarm: 350mA, plus 65mA/Watt Speaker Power

Note: All circuits are power limited.

Mircom QX-5000 Series User Manual

Other manuals for Mircom QX-5000 Series