Mircom TX3 Series - 2 TX3 Nano Configurator; Passwords; Sign into the Configurator

To Next Page

To Previous Page

TX3 Nano Configuration Manual 13

2 TX3 Nano Configurator

This chapter provides an overview of the TX3 Nano Web-based Configurator.

This chapter explains

• Passwords

• Sign into the Configurator

• Global Settings

• Backup and Restore

• Factory Reset

•Sign Out

2.1 Passwords

The TX3 Nano has 2 passwords.

• The Configurator password is used to sign into the web-based

Configurator. The default is admin. When you change it, you must choose

a password of at least 6 digits.

• The panel password is used to access settings on the TX3 Nano display

(see section 8.5 on page 63). The default is 111111. It can be a maximum

of 6 numbers.

For security, the first time that you sign into the web-based Configurator, you

will be prompted to change both passwords.

2.2 Sign into the Configurator

You must configure the TX3 Nano with a Web browser.

Note: The TX3 Nano does not work with Internet Explorer.

Get the IP Address of the TX3 Nano

1. Connect the TX3 Nano’s RJ45 connector to a LAN.

2. Press and hold the Home button for 10 seconds.

Other manuals for Mircom TX3 Series