62 TX3 Nano Configuration Manual
Copyright 2019
Using the TX3 Nano
• Call, Hang Up and Select: Press to call the select resident. Press again to
disconnect the call.
Press this button to select a group or subgroup of residents.
• Home and Back: Press to move to the top of the list of residents.
When in a group or subgroup, press again to go up one level.
Press and hold this button for 10 seconds to see the TX3 Nano’s IP
address, MAC address, and firmware version number.
8.3 The TX3 Nano Display
Figure 34. The TX3 Nano display
8.3.1 Icons in the Status Bar
List of Residents
Status Bar
Volume indicator
The TX3 Nano is configured with a list of residents (see section 4
on page 40)
The TX3 Nano does not have a list of residents
The TX3 Nano is registered with a SIP server
The TX3 Nano is attempting to register with the SIP server, but it
can still make SIP calls
To Next Page
Loading...
