Mircom TX3 Series - Backup and Restore; Figure 9. Backup and Restore

18 TX3 Nano Configuration Manual
Copyright 2019
TX3 Nano Configurator
2. In the Users section, select a user.
The Configurator shows the user’s last login time.
2.4 Backup and Restore
You can make a backup of the entire TX3 Nano network. Store the backup in a
safe place.
To back up the TX3 Nano network
1. Click the Global Settings button in the upper right corner of the
window.
2. In the Backup and Restore section, click Backup.
Figure 9. Backup and Restore
The web browser downloads the backup file and saves it in the browser’s
default folder. The name of the backup file is in the form:
backup-DD-MM-YYYY.t4
To restore the TX3 Nano network
1. Click the Global Settings button in the upper right corner of the
window.
2. In the Backup and Restore section, click Choose file.
3. Navigate to the backup file, then click Open. TX3 Nano backups have the
extension .t4.
4. Click Restore.
The Configurator erases the current configuration and restores the
backup. When the restoration is complete, the TX3 Nano will restart and
you will be signed out of the Configurator.
Note: The Restore feature restores all the TX3 Nanos on the network. If a
TX3 Nano was removed from the network after the backup was
performed, then this TX3 Nano will be restored, but it will have a
broken link in the network list (section 3.2 on page 22).