Mircom TX3 Series - Screensaver; Sign out

20 TX3 Nano Configuration Manual
Copyright 2019
TX3 Nano Configurator
2.6 Screensaver
You can upload a maximum of 19 images that the TX3 Nano will display in a
slideshow as a screensaver. The screensaver starts after 5 minutes of inactivity.
Each image file must be less than 5 MB, and must have a minimum resolution of
480x272 pixels. The supported file formats are .jpg, . jpeg, .gif, and .png.
Note: The image showing the instructions for using the TX3 Nano
(beginning with Press Up, Down arrow keys to navigate) cannot
be deleted.
Upload an image file to the TX3 Nano screensaver
1. In the Screensaver section, click Choose File.
2. In the window that appears, navigate to the image file and select it.
3. Click Open.
4. Click Save Screensaver.
5. Repeat these steps to upload another image file.
Delete an image file from the TX3 Nano screensaver
1. In the Screensaver section, select an image.
2. Click Delete Screensaver.
2.7 Sign Out
Signing out takes you to the sign in page. If other people are using the computer,
you should sign out when you are finished.
Sign out
• To sign out, click the icon in the upper right corner.