Mircom TX3 Series - Networking; Figure 1. TX3 Nano on an IP Network

Introduction
TX3 Nano Configuration Manual 7
Copyright 2019
• Touch buttons for scrolling the directory and making calls
• Storage of up to 1000 names
• Hands-free full duplex communication
• Dials up to 20 digit telephone numbers
• System can be configured over an IP network using a Web-based
configurator
1.2 Networking
By default, the TX3 Nano is assigned an IP address from a DHCP server.
DHCP (Dynamic Host Configuration Protocol) is a way of assigning IP
addresses to devices on a network.
The TX3 Nano can be connected to an existing TX3 network, as shown in
Figure 1. The TX3 Nano supports IPv4 addresses. The TX3 Nano and other TX3
devices can communicate with each other through correlations.
Figure 1. TX3 Nano on an IP Network