TX3 Nano Settings
TX3 Nano Configuration Manual 25
Copyright 2019
3.9 Resident Access Schedules
1. In the Resident Access Schedules section, provide information for each of
the following:
Allow calls. Use this selection to allow calls to the residents based on the
selected schedule.
• If Always is selected, then visitors can always make calls to
residents. This is the default.
• If Never is selected, then visitors can never make calls to
residents.
• If a schedule is selected, then visitors can make calls to residents
only when the schedule is active.
Allow unlock. Use this selection to allow the residents to use their phone
to unlock the door during a set schedule.
• If Always is selected, then residents can always use their phones to
unlock the door. This is the default.
• If Never is selected, then residents can never use their phones to
unlock the door.
• If a schedule is selected, then residents can use their phones to
unlock the door only when the schedule is active.
For example, if Allow calls is Always and Allow unlock is set to a
schedule, then visitors can always call residents, but residents can unlock
the door only when the schedule is active. If Allow calls is set to a schedule
and Allow unlock is Never, then visitors can call residents only when the
schedule is active, but residents cannot unlock the door.
2. Click Save Changes at the top of the window.
3.10 Keypad
This feature lets you specify how the resident unlocks the door for the visitor.
Configure how the resident unlocks the door
1. In the Keypad section, provide information for each the following:
Open Door by Pressing. Specify which key on the resident’s phone
unlocks the door. The default is 9.
Note: Do not select 4 (this is used to refuse entry or disconnect).
To Next Page
Loading...
