Using the TX3 Nano
TX3 Nano Configuration Manual 63
Copyright 2019
8.4 Screensaver
After 5 minutes of inactivity, the screensaver starts (see section 2.6 on page 20)
Press any button to stop the screensaver.
8.5 Panel Settings
You can configure the network settings and the time from the TX3 Nano display.
Access the panel settings
1. Press and hold the Home button for 10 seconds.
The TX3 Nano’s MAC address, IP address, application version, panel ID,
location, and date and time appear on the display.
2. While still holding the Home button, press the Call button.
The Enter Password screen appears.
3. Enter the panel password. Press the Scroll up and Scroll down buttons to
move up and down the list of numbers, and press the Call button to select
a number. The default panel password is 111111.
The TX3 Nano is not registered with the SIP server, but it can still
make SIP calls
The TX3 Nano’s SIP account details are not complete (see section
3.11 on page 26), and it cannot make SIP calls
Cellular network signal strength indicator (cellular models only)
The SIM card is not present, but the module is receiving medium
signal strength (cellular models only)
A phone line is connected to the TX3 Nano
A phone line is not connected to the TX3 Nano
To Next Page
Loading...
