5330/5340 IP Phones – User Guide
- 98 -
Feature Function
Out of range
Repetitive 3-pitch tone until you are back in range. Note: If you
are out of range for more than 10 seconds, any call that is in
progress is dropped and not recovered.
Note: Audio indications are heard in the handset only when it is in use and may interrupt
voice transmission.
Cordless Handset LEDs
The handset has two LEDs:
• Blue – indicates the operational status of the handset
• Green – indicates the status of the electrical charge of the battery
LED
Color
LED State
Indicates
Solid Handset is muted
Blinking Handset is in pairing mode
Winking Active audio path between Handset and Module
Blue
Off No audio path between Handset and Module OR
Battery is dead
Solid Battery is fully charged
Blinking
Battery is charging. Note: It is normal for the handset LED to cycle
between blinking and solid as battery charge is maintained.
Green
Off When handset is cradled and the LED does not flash or illuminate, this
indicates an absence of battery power. During the first 30 – 60 minutes
that the light is off, the battery may be trickle charging. If that is the
case, the LED will resume normal behavior within that 60 minute period.
If the LED remains off for more than 60 minutes, then either the battery
is no longer chargeable or there is a problem in the charging circuit.
Blinking: LED is On and Off for equal amount of time
Winking: LED is On for a short period of time and Off for a longer period
USING THE CORDLESS HEADSET
The cordless headset offers the same capability as the cordless handset to make and answer
telephone calls away from your desk while adding the convenience of hands-free operation.
When not in use, the cordless headset sits in the headset charging cradle.
To use the Cordless Headset, you must pair the headset with the phone. For more
information, see “Pairing the Cordless Module and Accessories” on page 94.
To Next Page
Loading...
