5330/5340 IP Phones – User Guide
- 100 -
Dialing – Auto Dial Enabled
To dial with Auto Dial enabled:
To dial the predefined Auto Dial number, press the hookswitch on the cordless handset or
headset.
To program Auto Dial, refer to Using the Cordless Devices Application on page 101.
Headset Alerting Tones and LEDs
The cordless accessories provide the following alerting tones:
Feature Function
Mute ON/OFF 2-pitch tone occurs immediately. Reminder tone occurs 30
seconds after activation and then regularly until deactivated.
Mute key on Phone ON/OFF No immediate tone. Reminder tone occurs 30 seconds after
activation and then regularly until deactivated.
Low battery (within 10 minutes left) 3 beeps and 20 second pause
Low battery (within 2 minutes left) 3 rapid beeps and 1.5 second pause
Out of range Repetitive 3-pitch tone until you are back in range. Note: If
you are out of range for more than 10 seconds, any call that
is in progress is dropped and not recovered.
Cordless Headset LEDs
There are two LEDs associated with the cordless headset:
• A blue LED on the headset indicates the headset status
• A green LED in the headset charging cradle indicates battery status
LED Color LED State Indicates
Solid Headset mic is muted
Blinking Headset is in pairing mode
Winking Active audio path between Headset and Module
Solid for 2
seconds
Pairing successful OR
New battery installed
Blue
(on headset)
Off No audio path between Headset and Module OR
Battery is dead
Solid Battery is fully charged
Blinking
Battery is charging. Note: It is normal for the headset LED to cycle
between blinking and solid as battery charge is maintained.
Winking Indicates low voltage when headset is uncradled
Green
(on cradle)
Off When headset is cradled, indicates battery is not charging.
Blinking: LED is On and Off for equal amount of time
Winking: LED is On for a short period of time and Off for a longer period
To Next Page
Loading...
