Mitel 5330 - Cordless Devices Application; Configuring Auto Dial for Cordless Devices

5330/5340 IP Phones – User Guide
- 101 -
USING THE CORDLESS DEVICES APPLICATION
The Cordless Devices Application provides access to module information and pairing for
hand- or headsets.
To access the Cordless Devices Application, do one of the following:
• Press the blue Applications
key and then press Cordless Devices
• Press a feature key you have programmed as the Cordless Devices Application key.
For information about programming feature keys, see page 41.
Note: When the pairing button on the Cordless Module is pressed, or when the battery
level of a cordless accessory is critically low, the phone will automatically open the
Cordless Devices Application.
Viewing Cordless Module Information
You can use the Cordless Module Application to view protocol, firmware, and hardware
information about the module.
To view cordless module information
1. Access the Cordless Module Application.
2. Press Cordless Module Info. Device information appears on the screen.
3. Press Close to exit.
Low Battery Level
When the battery of a cordless device reaches a near-critical level, the phone displays a
warning. Until the battery is recharged (or until it becomes fully discharged), the warning is
repeated at each new call made using the Prime Line. To continue with a call while charging
the cordless accessory, switch to speakerphone and then cradle the cordless accessory.
Auto Dial
When a Cordless Module is installed and at least one device is paired, the Auto Dial feature
is available in the Settings menu. You can program a number that is automatically dialed
when a cordless device hookswitch button is pressed.
To program an Auto Dial number:
1. Press Settings.
2. Press Auto Dial, and then press Edit Number.