FEATURE KEYS
BQTH
Allows the Attendant to speak to two calls at the Console at once.
SWAP
Allows the Attendant to speak privately with one caller while holding
the other when there are two calls at the Console. Successive presses
of SWAP allows the Attendant to alternate between the two calls.
RELEASE
Used for disconnecting and transferring calls.
BELL
Turns the Console ringer on or off. If the ringer is off, the word “MUTE”
appears on the display. Incoming calls are announced by the “BELL” in
the display, as well as the ringer, if it is on.
NIGHT
Puts the SX-50@ into Night Service in which calls are routed to
specially assigned numbers or to Night Bells. The display shows
“NIGHT”. Another press returns it to regular Day Service. This key may
also be. used to change Night Answer Points for incoming trunks.
ALARM
If the diagnostic system detects a fault, the bell rings and the ALARM
lamp flashes. Pressing ALARM silences the bells and displays the alarm
code, which is stored for later examination by the Maintenance
Engineer.
HOLD 1, 2, and 3
Allow the Attendant to place up to three calls to the console on hold.
The key lamp lights to indicate a calf on hold.
ANSWER -
Allows you to answer single calls or the incoming call which has been
waiting longest.
;-
.:
.
,‘L :
‘: .:
,:
..;
‘,
l-8 Overview
-
To Next Page
Loading...
