햴
Continue to enter the program as previously described so that the following display is
achieved:
When entering the PV and CV values, use the variable buttons respectively.
Adding entries to the GVL
Note, in particular: “Reset_In” (Global) - is a new Input mapped from the MELSEC boolean
address X02 or IEC %IX2. This requires a new entry into the GVL as follows:
Application Program Building a Project
4-26 MITSUBISHI ELECTRIC
햳
Click on
Apply
, then
Update
and the variable name will change as
shownontheleft.
To Next Page
Loading...
