Mitsubishi Electric FX Series - Network Module for AS-Interface

2.9.9 Network Module for AS-Interface
The Actuator Sensor interface (AS interface or ASi) is an international standard for the lowest
field bus level. The network suits versatile demands, is very flexible and particularly easy to
install. The ASi is suitable for controlling sensors, actuators and I/O units.
쎲
The special function module can be used with a base unit or expansion unit of this series.
쑗
The special function module cannot be used with this series.
Extending for Special Functions The Hardware
2-30 MITSUBISHI ELECTRIC
FX -32ASI-M
2N
CONFIG ERR
FROM/TO
PRG ENABLE
ASI ACTIVE
PRJ MODE
ADRESS/ERROR
POWER
U ASI
The FX2N-32ASI-M serves as master module for the con
-
nection of the FX
1N/FX2N and FX3U/FX3UC PLC to the
AS-Interface system. Up to 31 slave units with up to 4
inputs and 4 outputs can be controlled.
For status and diagnosis messages a 7-segment display
is integrated.
Module type Designation Description FX1S FX1N FX2N FX2NC FX3G FX3U
Special function module FX2N-32ASI-M
Master for
AS-i system
쑗쎲쎲쑗쑗쎲