Mitsubishi Electric FX Series - Error Codes 6501 to 6510

A.3.2 Error codes 6501 to 6510
Appendix Error Code List
Training Manual GX IEC Developer A - 11
Error
Special
Register
Error
Code
Description Corrective Action
Parameter error D8064
0000 No error —
6401 Program sum check error
STOP the PLC, and cor
-
rectly set the parameters.
6402 Memory capacity setting error
6403 Latched device area setting error
6404 Comment area setting error
6405 File register area setting error
6406
Special unit (BFM) initial value setting,
positioning instruction setting sum
check error
6407
Special unit (BFM) initial value setting,
positioning instruction setting error
6409 Other setting error
Error
Special
Register
Error
Code
Description Corrective Action
Syntax error D8065
0000 Kein Fehler
During programming, each
instruction is checked. If a
syntax error is detected,
modify the instruction
correctly.
6501
Incorrect combination of instruction,
device symbol and device number
6502
No OUT T or OUT C before setting
value
6503
앥 No OUT T or OUT C before setting
value
앥 Insufficient number of operands for
an applied instruction
6504
앥 Same label number is used more
than once.
앥 Same interrupt input or high speed
counter input is used more than
once.
6505
Device number is out of allowable
range.
6506 Invalid instruction
6507 Invalid label number [P]
6508 Invalid interrupt input [I]
6509 Other error
6510 MC nesting number error