Mitsubishi Electric FX Series - Error Codes (D8060 to D8069; Extension Boards

A.2.4 Error Codes (D8060 to D8069)
*
Cleared when PLC switches from STOP to RUN.
A.2.5 Extension Boards (Dedicated to FX1S and FX1N)
Special Registers Appendix
A-8 MITSUBISHI ELECTRIC
Special Register Read Write CPU Function
D8112
쏹
—
FX
1S
FX1N
Adapter FX1N-2AD-BD: Digital input value ch.1
D8113
쏹
— Adapter FX
1N-2AD-BD: Digital input value ch.2
D8114
쏹쏹
Adapter FX
1N-1DA-BD: Digital output value ch.1
Special Register Read Write CPU Function
D8060
쏹
—
FX
2N
FX2NC
FX3G
FX3U
FX3UC
If the unit or block corresponding to a programmed I/O number
is not actually loaded, M8060 is set to ON and the first device
number of the erroneous block is written to D8060
Meaning of the four digit code:
1st digit: 0 = Output, 1 = Input
2nd to 4th digit: First device number of the erroneous block
D8061
쏹
—
FX
1S
FX1N
FX2N
FX2NC
FX3G
FX3U
FX3UC
Error code for PLC hardware error
D8062
쏹
—
FX
2N,
FX
2NC
FX3G
FX3U
FX3UC
Error code for PLC/PP communication error
FX
3G Error code for serial communication error [ch0]
D8063
쏹
—
FX
1S
FX1N
FX2N
FX2NC
FX3G
FX3U
FX3UC
Error code for serial communication error 1 [ch1]
D8064
쏹
— Error code for parameter error
D8065
쏹
— Error code for syntax error
D8066
쏹
— Error code for ladder error
D8067
쏹
— Error code for operation error
D8068*
—
쏹
Operation error step number latched
In case of 32K steps or more, the step number is stored in
[D8313, D8312].
D8069*
쏹
—
Error step number of M8065 to M8067
In case of 32K steps or more, the step number is stored in
[D8315, D8314].