9.2 Online Program Change
Where complete networks are to be added or removed, the “Online Program Change” operation
must be used. This method is the preferred method of making changes to the program whilst
on-line. For example: If the recently added counter network is to be removed from the program,
carry out the following procedure (Remember the PLC and GX IEC Developer programs must
be identical before proceeding).
햲
Highlight network 3 on the POU body “MOTOR_CONTROL” and press "Delete" on the key
-
board.
Online Mode Online Program Change
Training Manual GX IEC Developer 9 - 3
햳
Invoke the
Online Program Change
feature from the
Project
Menu. GX IEC Developer will compile and write the online change
automatically.
To Next Page
Loading...
