Mitsubishi Electric M800VS Series - Setting the Program Execution Order

M800VS/M80V Series Connection and Setup Manual
20 Sequence Program Writing
20.5 Setting the Parameters on GX Works2
430
IB-1501613-A
20.5.4 Setting the Program Execution Order
In the following cases, set the execution method and execution order to sequence programs.
 When creating the sequence programs with the multi-program method
 When creating sequence programs of main process with ST language
This operation is required before a sequence program is executed on the CNC controller, and parameter files must be written
to the CNC controller.
 If this operation is not completed when the multi-program method is in use or when creating sequence programs of main
process with ST language, an error will occur on the RUN of sequence programs.
(1) Select the [Program] tab.
(2) Select the name of the sequence program to be registered for execution from the program list on the left side of the fol-
lowing screen, and press [Insert]. Select the execution mode from the registered program list on the right side.
(3) After registering all sequence programs to execute, click [End].
Note