M800VS/M80V Series Connection and Setup Manual
41 Appendix 6: Restrictions for Lithium Batteries
41.1 Restriction for Packing
610
IB-1501613-A
41.1 Restriction for Packing
When transporting lithium batteries with means such as by air transport, measures corresponding to the United Nations
Dangerous Goods Regulations (hereafter called "UN Regulations") must be taken.
The UN Regulations classify the batteries as dangerous goods (Class 9) or not dangerous goods according to the lithium
metal content. To ensure safety during transportation, lithium batteries (battery unit) directly exported from Mitsubishi are
packaged in a dedicated container (UN package) for which safety has been confirmed.
When the customer is transporting these products with means subject to the UN Regulations, such as air transport, the
shipper must follow the details explained in the section "Transportation Restrictions for Lithium Batteries: Handling by User".
The followings are restrictions for transportation. Each restriction is specified based on the recommendation of the United
Nations.
41.1.1 Target Products
The following Mitsubishi Electric CNC products use lithium batteries. If the lithium metal content exceeds 1 g for battery cell
and 2 g for battery, the battery is classified as dangerous good (Class 9). In order to avoid an accidental actuation during the
transportation, all lithium battery products incorporated in a machinery or device must be fixed securely and must be shipped
with wrapped over the outer package as to prevent damage or short-circuits.
(1) Materials falling under Class 9
(2) Materials not falling under Class 9
(1) If the number of batteries exceeds 24 batteries for the battery cell or 12 batteries for the battery, the dedicated packing
(for materials falling under Class 9) is required.
Area Transportation method Restriction Special clause
World Air ICAO, IATA -
World Marine IMO 188
United States All (air, marine, land) DOT 49 CFR 173.185
Europe land RID, ADR -
Mitsubishi type (Type for ar-
rangement)
Battery type
Lithium met-
al content
Number of in-
corporated
batteries
Application
(Data backup)
Battery
class
Outline dimension
drawing
CR23500SE-CJ5
CR23500SE-
CJ5
1.52 g - For NC SRAM (M500) Battery cell
Refer to "Battery Op-
tion" in the specifica-
tion manual for drive
unit you are using for
the outline dimen-
sion drawing for ser-
vo.
Mitsubishi type (Type for ar-
rangement)
Battery type
Lithium met-
al content
Number of in-
corporated
batteries
Application
(Data backup)
Battery
class
Outline dimension
drawing
CR2032 (for built-in battery) CR2032 0.067 g - For NC SRAM
Battery cell
Refer to "Battery Op-
tion" in the specifica-
tion manual for drive
unit you are using for
the outline dimen-
sion drawing for ser-
vo.
CR2450 (for built-in battery) CR2450 0.173 g - For NC SRAM
ER6/ER6V series
(for built-in battery)
ER6, ER6V 0.65 g -
For NC SRAM/servo en-
coder
MR-BAT ER17330V 0.48 g - For servo encoder
Q6BAT Q6BAT 0.57 g - For NC SRAM
MDS-BAT6V1SET
2CR17335A 1.2 g 2 For servo encoder Battery
MR-BAT6V1SET
To Next Page
Loading...
