Mitsubishi Electric M800VS Series - SD Interface (Memory I;F Card); LAN Interface (Control Unit)

M800VS/M80V Series Connection and Setup Manual
4 General Specifications
4.18 Specifications and Precautions of USB/SD/LAN Interface
181
IB-1501613-A
4.18.2 SD Interface (Memory I/F card)
(*1) SDXC is not supported.
 Precautions for use of commercially available SD card
Mitsubishi Electric will not provide performance guarantee and maintenance for commercially available SD card, mini SD card
or micro SD card (requires converting adapter). When any of them is to be used, careful performance check must be required
by the machine tool builder.
Commercially available devices may not be compatible with Mitsubishi Electric units or suitable FA environment for
temperature- or noise-wise.
 Precautions for insertion/removal of SD card
When inserting/removing an SD card, turn the Mitsubishi Electric device's power OFF. Do not pull out the card or turn OFF the
power during access to the SD card. Failure to observe this could cause the memory contents to be erased.
In case of emergency, always perform backups by having your important data duplicate, etc. as MITSUBISHI will not
guarantee the broken or lost data.
4.18.3 LAN Interface (Control Unit)
(*1) Data transfer speed is the theoretical value on the standard, and the actual speed will be inferior to the value listed
above. The transfer speed may be restrained depending on the specification of the connected device.
(1) When half-duplex communication is made, the response time may become long depending on the connected device.
Use full-duplex communication to connect with the opposite device via a switching HUB.
 Precautions for selection of LAN cable
Make sure to select the LAN cables which are "category 5e or above" and "shielded". Cable wire material with double
shielded, which is appropriate for FA environment., is recommended.
Standards SD/SDHC (*1)
Transfer speed According to the connecting SD card
Maximum capacity 32 GB
Number of free ports Front × 1, Rear × 1
Standards 100BASE-TX/10BASE-T
Data transfer speed (*1) 100 Mbps/10 Mbps
Number of free ports Control unit × 2
Note