M800VS/M80V Series Connection and Setup Manual
25 Setting the Position Switches
25.3 Canceling the Position Switch
500
IB-1501613-A
25.3 Canceling the Position Switch
Enter a position switch number to be canceled (#75*1) in "# ( )" and a slash in "DATA ( )" on the setting field, then press the
[INPUT] key. Axis name of the specified position switch will be deleted, and the position switch is disabled. However, the data
in <dog1> and <dog2> are still retained in a memory. To enable the position switch again, only an axis name is required for
setting.
To Next Page
Loading...
