Mitsubishi Electric M800VS Series - Page 558

M800VS/M80V Series Connection and Setup Manual
29 Deceleration Check
29.4 Parameters
527
IB-1501613-A
 Designating in-position check width
[Servo parameters]
[Axis specification parameters]
# Item Description Setting range
2224 SV024 INP
In-position detection width Set the in-position detection width.
Set the positioning accuracy required for the machine.
The lower the setting is, the higher the positioning accuracy gets;
however, the cycle time (setting time) becomes longer.
The standard setting value is "50".
0 to 32767
(μm)
13024 SP024 INP
In-position detection width Set the in-position detection width.
Set the positioning accuracy required for the machine.
The lower the setting is, the higher the positioning accuracy gets;
however, the cycle time (setting time) becomes longer.
The standard setting value is "875".
0 to 32767
(1°/1000)
# Item Description Setting range
2077 G0inps
G0 in-position width Set the in-position width for G0.
Between SV024 and this parameter, the parameter with a larger
value will be applied.
When set as "0", this parameter will be invalid: only SV024 will
be available.
0.000 to 99.999
(mm)
2078 G1inps
G1 in-position width Set the in-position width for G1.
Between SV024 and this parameter, the parameter with a larger
value will be applied.
When set as "0", this parameter will be invalid: only SV024 will
be available.
0.000 to 99.999
(mm)