9-15
<Crew-cab vehicle>
The rear heater blows warm air from below the rear
seat. Select the desired blower speed by pressing
the LO or HI side of the rear heater switch. When
operation of the rear heater is not required, keep
the switch in its middle position (with neither the LO
nor HI side pressed).
NOTE:
The heater uses the heat produced by the engine
coolant. Warm air is, therefore, not available until
the coolant temperature becomes sufficiently high.
• Make sure the outside air inlets are not cov-
ered or otherwise obstructed. Remove any
object that is covering or otherwise obstructing
them. Unless the inlets are unobstructed, air will
not flow smoothly from the outlets when outside
air is selected.
• Do not directly apply steam from a cleaner to the
outside air inlets. Water could enter the cab, and
the wiper motor could malfunction.
Rear heater
Outside air inlets
Z08899
Z21382
FE_FG.book Page 15 Monday, December 19, 2011 4:22 PM
To Next Page
Loading...
