5-36 Switches and controls
• Actions to take after stopping the vehicle
1. Place the gearshift lever in the “P” position and
shut off the engine.
2. Restart the engine. If the engine cannot be
started, contact an authorized dealer.
3. If the warning (amber) is not indicated after
the engine is started, you may continue to drive
the vehicle. If the warning is indicated again,
operate the gearshift lever in the manual shift
mode. You may continue to drive if manual gear
shifting is possible. However, have the vehicle
inspected by an authorized dealer as soon as
possible. If manual gear shifting is impossible,
do not continue to drive but contact an autho-
rized dealer.
10.3 warning
• If the warning appears:
• Place the gearshift lever in the “P” position, and
run the engine slightly above idling speed by
depressing the accelerator pedal to cool down
the transmission.
• If the warning disappears, you may continue to
drive. If the warning remains on or is indicated
repeatedly, transmission oil leakage may be the
cause. Contact an authorized dealer.
CAUTION
Do not stop the engine without letting the trans-
mission cool down, otherwise the transmission
may seize up. Stop the engine only after the
warning has disappeared from the screen.
Cruise control memorizes any desired speed above
the speed indicated below and, maintains that
speed automatically without having to operate the
accelerator pedal. This is especially useful for free-
way driving when there is little chance of having to
pull over and stop.
Cruise control
Speeds above which cruise control functions
Approx. 30 km/h (18 mph)
Z21544
Z21312
FE_FG.book Page 36 Monday, December 19, 2011 4:22 PM
To Next Page
Loading...
