4-7
1.1 Seat belt anchor
<Driver’s seat>
Adjust the seat belt anchor upward or downward
to ensure that the belt passes across your shoulder.
You will need to keep the lock button pulled while
moving the seat belt anchor downward. When the
seat belt anchor has reached the desired position,
release the lock button and jiggle the seat belt
anchor up and down to make sure it is locked in
place.
2Lap belt
•
Fastening
1. Take care that the belt does not become twisted.
Insert the tang into the buckle until you
hear a click.
2. Pull on the tang to confirm that it is locked in.
3. Adjust the belt so it is low across your hips.
4. To adjust the belt’s length, hold the tang at 90°
to the belt.
Pull the belt end to shorten the belt or the tang
to lengthen it.
To lengthen
To shorten
• Unfastening
1. Press the red button to unlock the buckle.
2. When the belt is not in use, insert its tang into
the buckle.
WARNING
The shoulder belt can be dangerous if worn
across the neck. Adjust its position so that it
does not cross over the neck.
WARNING
For maximum protection in the event of an
accident, the belt must not be loose. A loose
belt could even aggravate injuries.
Z08772
Z20955
FE_FG.book Page 7 Monday, December 19, 2011 4:22 PM
To Next Page
Loading...
