12-10 Simple inspection and service
4 Checking locking of the cab
When the cab is lowered down, the state of locking
should be checked as follows. If incomplete locking
is identified, repeat the cab tilting procedure and
lower once again. If incomplete locking still exists,
never drive the vehicle and contact your authorized
dealer.
1. Confirm that the latch is fully engaged with
the pin . Also confirm that lever B does not
move when it is pulled.
2. Confirm that the cab does not rise up when lever
C is pulled.
3. Turn the starter switch to the “ON” position, then
make sure the multi-information display does
not indicate the warning.
WARNING
Do not drive the vehicle while the multi-infor-
mation display is showing . Vibration
could cause the cab to rise. If the multi-infor-
mation display is showing , tilt, lower and
lock the cab again.
Z21841
Z20948
FE_FG.book Page 10 Monday, December 19, 2011 4:22 PM
To Next Page
Loading...
