12-36 Simple inspection and service
4. After oil has drained out completely, install and
tighten the drain plug.
5. Add oil through the inspection plug hole until it
reaches the bottom of the hole.
6. Like with the drain plug, replace the inspection
plug gasket with a new one and install the plug
by tightening it to the specified torque.
6 Brake fluid
Have the brake fluid replacement performed by an
authorized dealer.
Recommended fluid:
Brake fluid SAE J1703
FMVSS No. 116, DOT3
Tightening
torque
110 ± 10 N·m (81 ± 7 ft.lbs.,
11 ± 1 kgf·m)
Tightening
torque
110 ± 10 N·m (81 ± 7 ft.lbs.,
11 ± 1 kgf·m)
Inspection
intervals
At the time of pre-operational
check
Replacement
intervals
Every 24 months
FE_FG.book Page 36 Monday, December 19, 2011 4:22 PM
To Next Page
Loading...
